Echelon NodeUtil Node Utility Manuel d'utilisateur télécharger pdf (Page 12)

6 Using NodeUtil

Starting NodeUtil

To start the NodeUtil Node Utility, perform the following steps:

1. Open a Windows command prompt.

Windows 7: Start → All Programs → Accessories → Command Prompt

Windows XP: Start → Programs → Accessories → Command Prompt

2. If you installed NodeUtil in a directory that is not in your Windows path,

use the cd (change directory) command set the current directory to the

folder that contains the NodeUtil.exe file.

3. Enter NodeUtil, with appropriate command-line parameters (as

described in the next section,

Command-Line Parameters

), to start the

NodeUtil Node Utility.

Alternatively, you can use a Windows shortcut for the NodeUtil Node

Utility; see

Creating a Shortcut to NodeUtil

on page 8.

When the NodeUtil Node Utility starts, it displays introductory text similar to

the following text, followed by the NodeUtil main menu (see

The NodeUtil Main

on page 9):

If NodeUtil cannot open the network driver, NodeUtil displays an error message

similar to the following message, and exits.

In this case, check that the network driver is loaded correctly, that you have

OpenLDV 3.3C or later installed, and that your network interface hardware is

correctly configured.

Command-Line Parameters

The NodeUtil command has the following format:

nodeutil <command-line-parameters>

Echelon Node Utility Release 2.21

Received uplink local reset

Successfully installed TP/FT-10 network interface.

Welcome to the Echelon Node Utility application.

Activate the service pin on remote device to access it.

Enter one of the following commands by typing the indicated letter:

Echelon Node Utility Release 2.21

Error initializing network interface (LON1): could not open network

driver

1 2 ... 7 8 9 10 11 12 13 14 15 16 17 ... 39 40

Pas de commentaire

Echelon NodeUtil Node Utility Manuel d'utilisateur Page 12